Hydraulic paper cutter in use, there is a paper press but not under the knife failure, what is the reason for this? How to solve? In this paper, we bring you the hydraulic paper cutter is not a knife failure.

1, hydraulic paper cutter does not cut the knife may be the cause of the cutter's sensor problems, such as is not moving the position, we just move the sensor back to the original position to solve the problem of the knife.

2, hydraulic paper cutter is not a knife may also be caused by a short circuit line, generally speaking, easy to appear short-circuit location has a square bridge, circuit board, host, if it is a short-circuit failure, we only need to replace the short-circuit part can be used normally.

3, hydraulic paper cutter does not knife may also be mechanical pressure spring spring force is not enough to cause, we just need to increase the pressure can be, if you try to increase the pressure is still not resolved, then only the spring can be replaced. Here it should be noted that more than one with the spring, even if only one of them to be a broken, then the other did not break to be replaced together, can not only replace the broken one, otherwise there will be uneven pressure or pressure is not enough, resulting in the failure of the knife.

4, wear and tear or improperly adjusted, will cause the gap between the knife seat and the slider becomes large, the gap is too large a few sentences will make the knife seat is not stable, this time the hydraulic paper cutter will not appear knife failure. If this is the reason, we need to re-adjust the gap between the knife seat and the slide.